Extruder &amp; Bed

Z-Probing problems on delta printer / z-probe triggered before starting probing

1.3K views 4 comments 0 points Most recent by dec February 2016

Extrusion Flowrate Adjustment Malfunction

242 views 2 comments 0 points Most recent by Intechgreater February 2016

bed cooling

107 views 3 comments 0 points Most recent by Repetier January 2016

Extruder Reverses Filament Prior to Print

96 views 3 comments 0 points Most recent by Repetier January 2016

Bed auto leveling and -2.1mm offset

1.5K views 6 comments 0 points Most recent by Repetier January 2016

Manual bed levelling procedure (by display)

925 views 2 comments 0 points Most recent by Morpheus69 January 2016

Temperature won't rise in software

211 views 2 comments 0 points Most recent by bombawut January 2016

I need the correct offsets for FSR's mounted under the bed.

196 views 3 comments 0 points Most recent by Repetier January 2016

Dimensional Inaccuracies

233 views 4 comments 0 points Most recent by Repetier January 2016

Heated Bed always on

469 views 7 comments 0 points Most recent by Repetier January 2016

extruder won't extrude

222 views 1 comment 0 points Most recent by Repetier January 2016

Z-probe and autoleveling on my mendelmax 1.5 need help

391 views 7 comments 0 points Most recent by docpayce January 2016

EXT0 Temp wont rise

213 views 3 comments 0 points Most recent by enggmaug December 2015

The temperature does not rise

255 views 8 comments 0 points Most recent by Repetier December 2015

The extruder motor doesn't work

1.3K views 20 comments 0 points Most recent by orbita December 2015

Using a Thermocouple with Repetier

1.4K views 4 comments 0 points Most recent by Repetier December 2015

Firmware V0.91 auto bed levelling Z offset

585 views 3 comments 0 points Most recent by Repetier December 2015

Modification of x axis

64 views 1 comment 0 points Most recent by Repetier November 2015

Extruder will only heat up manualy.

177 views 1 comment 0 points Most recent by OGStyle November 2015

Heater Decoupled by Fan

1K views 7 comments 0 points Most recent by FireflyNJ November 2015

heat bed and extruder

252 views 1 comment 0 points Most recent by Repetier November 2015

No Extruder Control

148 views 4 comments 0 points Most recent by kwebersole November 2015

3 extruder fan problem, one extruder no problem fan ?

230 views 8 comments 0 points Most recent by Repetier November 2015

Dead Time parameter has no influence at all

726 views 3 comments 0 points Most recent by Repetier November 2015

Z offset from Slic3r have no negative influence.

304 views 1 comment 0 points Most recent by Repetier October 2015

Autoleveling Feature Problem

288 views 3 comments 0 points Most recent by Repetier October 2015

Something wrong in that Z LEVELING TUTORIAL https://www.youtube.com/watch?v=L9URtv2LqKc