General

• Lost Filament Extrusion in Repitier/Slicr3

  267 views 4 comments 0 points Most recent by BuchnerB August 2015
• Manual Feed Rate Changes when print starts V1.54

  147 views 6 comments 0 points Most recent by caldata August 2015
• Mirror an Object on a non-Z axis

  682 views 2 comments 0 points Most recent by Mattia August 2015
• license kind

  187 views 3 comments 0 points Most recent by Repetier July 2015
• Repetier Host 1.5.0 good!

  429 views 1 comment 0 points Most recent by Repetier July 2015
• Jobs printing mirrored

  896 views 2 comments 0 points Most recent by kayjay July 2015
• Incorrect size

  179 views 1 comment 0 points Most recent by djenn June 2015
• Question, using script buttons

  219 views 2 comments 0 points Most recent by d0a1ta June 2015
• new printer start up help

  869 views 4 comments 0 points Most recent by joevianelli June 2015
• Print with second extruder

  282 views 4 comments 0 points Most recent by Blaster June 2015
• I can't set my bed temp in Repetier Host any higher than 90?

  664 views 3 comments 0 points Most recent by Repetier June 2015
• alligator vs radds

  439 views 2 comments 0 points Most recent by lazy_mosquito May 2015
• Firmware Upload Errors

  223 views 3 comments 0 points Most recent by Repetier May 2015
• Preview tab stop Repetier Host

  478 views 3 comments 0 points Most recent by Repetier April 2015
• how to use bed heigtht map

  274 views 3 comments 0 points Most recent by Repetier April 2015
• EXTRUDER not working

  341 views 1 comment 0 points Most recent by Repetier April 2015
• Where is the g-code output log?

  356 views 1 comment 0 points Most recent by Repetier April 2015
• z probe relay setting

  1.1K views 8 comments 0 points Most recent by Repetier April 2015
• Donated but didn't get credit for it

  111 views 1 comment 0 points Most recent by Repetier March 2015
• Debugging

  111 views 1 comment 0 points Most recent by Repetier March 2015
• Bed Auto Leveling problem

  303 views 0 comments 0 points Started by Faiotech March 2015
• Using Repetier Host 1.0.6 with PrintrBot Simple Metal

  481 views 3 comments 0 points Most recent by Repetier March 2015
• temperature curve , output bed

  882 views 2 comments 0 points Most recent by RepetierSupport March 2015
• how repetier works internally.

  206 views 1 comment 0 points Most recent by Repetier February 2015
• Y endstop resetting mid stroke

  110 views 0 comments 0 points Started by jhhoffman February 2015
• Awkward behavior on delta 3D printer

  362 views 1 comment 0 points Most recent by Repetier January 2015
• Printer stops during print

  529 views 1 comment 0 points Most recent by Repetier January 2015
• Repetier Host Manual?

  457 views 4 comments 0 points Most recent by Zaaphod January 2015
• Printing from SD card

  989 views 2 comments 0 points Most recent by professorburnout January 2015
• Delta Printer Z-Probe not looking right

  1.3K views 6 comments 0 points Most recent by Repetier January 2015