General

• Awkward behavior on delta 3D printer

  362 views 1 comment 0 points Most recent by Repetier January 2015
• Printer stops during print

  529 views 1 comment 0 points Most recent by Repetier January 2015
• Repetier Host Manual?

  457 views 4 comments 0 points Most recent by Zaaphod January 2015
• Printing from SD card

  989 views 2 comments 0 points Most recent by professorburnout January 2015
• Delta Printer Z-Probe not looking right

  1.3K views 6 comments 0 points Most recent by Repetier January 2015
• 3D View model invisible

  294 views 1 comment 0 points Most recent by Wischi December 2014
• Z position ignored

  633 views 1 comment 0 points Most recent by Repetier December 2014
• Extruder speed

  464 views 3 comments 0 points Most recent by Repetier December 2014
• Calibrating Rostock 3D printer

  1.2K views 1 comment 0 points Most recent by Repetier November 2014
• Saving settings in EEPROM

  448 views 1 comment 0 points Most recent by Repetier November 2014
• Towers on delta printer don't move

  218 views 2 comments 0 points Most recent by cearza November 2014
• Can I print a 2D draw with my delta printer?

  778 views 3 comments 0 points Most recent by cearza November 2014
• print one at a time

  669 views 1 comment 0 points Most recent by Repetier November 2014
• Filament color can not be changed

  438 views 1 comment 0 points Most recent by Repetier October 2014
• Unable to use the "P" aka PARK button

  169 views 1 comment 0 points Most recent by Repetier October 2014
• Can't see exact extruder temp

  137 views 4 comments 0 points Most recent by Repetier October 2014
• Manual extrac/retraction is WAY too fast

  471 views 1 comment 0 points Most recent by thecrazy October 2014
• 1.05 - how to enable log view ?

  460 views 1 comment 0 points Most recent by AASC October 2014
• Loss of extruder control with new Manual Control GUI

  259 views 2 comments 0 points Most recent by Bukobro October 2014
• Problems with solid infil on top layer

  629 views 0 comments 0 points Started by Dzhest October 2014
• Just want to say Hi!

  39 views 0 comments 0 points Started by JLrj September 2014
• xyz stepper motor configuration

  1.1K views 1 comment 0 points Most recent by Repetier September 2014
• Temperature changes with smart controller.

  374 views 7 comments 0 points Most recent by Xabbax September 2014
• Scaling in Negative #'s?

  149 views 1 comment 0 points Most recent by Repetier September 2014
• What are Loop Edges?

  353 views 1 comment 0 points Most recent by Repetier August 2014