Motor Control

• Low Z stepper resolution ignored

  399 views 2 comments 0 points Most recent by atratra March 2015
• quadstep low delay?

  261 views 1 comment 0 points Most recent by Repetier March 2015
• Servo pins

  1.1K views 2 comments 0 points Most recent by 3dMistery March 2015
• Change the speed for toolchange T0-->T1

  211 views 0 comments 0 points Started by Rufi February 2015
• moving problem

  702 views 3 comments 0 points Most recent by szivgy February 2015
• X direction is reversed

  686 views 2 comments 0 points Most recent by rtideas February 2015
• go home problem

  198 views 2 comments 0 points Most recent by szivgy February 2015
• z axis motor back and forth

  184 views 2 comments 0 points Most recent by szivgy February 2015
• X Y Z steppers move correctly with manual controls, not with gcode commands

  857 views 2 comments 0 points Most recent by Repetier January 2015
• Motor only moves in one direction

  1.6K views 6 comments 0 points Most recent by frans87 January 2015
• Z axis problem

  667 views 3 comments 0 points Most recent by Repetier January 2015
• Z Probing coming up with an error

  1.5K views 5 comments 0 points Most recent by Repetier January 2015
• Custom gantry, loses steps

  874 views 4 comments 0 points Most recent by palmerr December 2014
• stuck on full step

  376 views 3 comments 0 points Most recent by Auchen December 2014
• Problem with Z Axis ( only 1 of the 2 to stepper motor turning)

  1.6K views 2 comments 0 points Most recent by greenbeast December 2014
• Rough, wavy surface, motor vibrations

  1.5K views 6 comments 0 points Most recent by Repetier November 2014
• Lower speed limit

  364 views 1 comment 0 points Most recent by Repetier November 2014
• Very quick movements, loosing steps, loud vibration

  560 views 1 comment 0 points Most recent by Repetier November 2014
• CoreXY Loss of steps

  2.4K views 3 comments 0 points Most recent by Repetier November 2014
• Missing physical motor move - but thinks it has moved

  363 views 4 comments 0 points Most recent by Twistedair November 2014
• Correct settings for CoreXY

  5.2K views 6 comments 0 points Most recent by Repetier September 2014
• First layer Problem

  211 views 0 comments 0 points Started by Tetrasolv September 2014