Bug Reports

• Firmware 0.92.4 on Megatronics V3.0 wrong pins

  396 views 1 comment 0 points Most recent by Repetier September 2015
• Crashing during print

  301 views 1 comment 0 points Most recent by Repetier September 2015
• Extruder undefinitely feed when moving from control panel

  156 views 2 comments 0 points Most recent by furynick September 2015
• E-axis STEP-signal and advance algorithm

  278 views 5 comments 0 points Most recent by andin August 2015
• EEPROM Setting Won't Stay Set

  528 views 4 comments 0 points Most recent by Repetier August 2015
• Extruder not switching properly

  194 views 4 comments 0 points Most recent by Repetier June 2015
• G31 state H

  231 views 3 comments 0 points Most recent by Gigio May 2015
• Incorrect x,y coordinates in g-code

  128 views 1 comment 0 points Most recent by Repetier March 2015
• retract on heat up

  519 views 2 comments 0 points Most recent by Repetier March 2015
• v092: "use_advance" in combination with "drive_system 2"

  679 views 8 comments 0 points Most recent by Repetier March 2015
• Sound bug

  281 views 2 comments 0 points Most recent by furynick February 2015
• Auto-level bug

  524 views 6 comments 0 points Most recent by furynick February 2015
• loss of Y position on job complete/travel to park.

  164 views 1 comment 0 points Most recent by Repetier January 2015
• Not stopping when decoupled

  296 views 2 comments 0 points Most recent by furynick January 2015
• MAX6675

  406 views 0 comments 0 points Started by Rogash1 December 2014
• New / updated HAL breaks RADDS SDcard

  1.2K views 8 comments 0 points Most recent by Repetier November 2014
• Rumba Pinout

  632 views 1 comment 0 points Most recent by Repetier November 2014
• Pause error!!!

  557 views 4 comments 0 points Most recent by SONIC300077 November 2014
• configuration tool for version 0.92

  434 views 0 comments 0 points Started by SONIC300077 November 2014