Toggle navigation
Categories
Discussions
About Us
Privacy Policy
Sign In
Home
›
good_idea
›
Discussions
good_idea
work245@mail.ru I might help with MKS Gen-2Z v1.1 board
About
Username
good_idea
Joined
February 2017
Visits
58
Last Active
May 2023
Roles
Member
Activity
Discussions
17
Comments
38
Discussions
Could this calibration tool be used with Repetier firware?
1
view
1
comment
0
points
Most recent by
Repetier
April 2023
Questions & Answers
How to search for phrase or combination of words on forum?
1
view
0
comments
0
points
Started by
good_idea
July 2022
Tips & Tricks
What is the G-code to set the retract length?
1
view
3
comments
0
points
Most recent by
Repetier
April 2022
Questions & Answers
Is it possible/meaningful to use distortion correction without rotation correction?
1
view
2
comments
0
points
Most recent by
good_idea
January 2020
Repetier-Firmware
No need for Z-probing before print if G32 and G33 were executed even before reset?
1
view
9
comments
0
points
Most recent by
good_idea
February 2020
Questions & Answers
First layer height changes along X axis when autobedleveling enabled. G32 & G33 in starting script
1
view
12
comments
0
points
Most recent by
Repetier
October 2018
Questions & Answers
How to automate enclosure temperature?
1
view
1
comment
0
points
Most recent by
Repetier
February 2018
Repetier-Firmware
Rep server Image does not fit to 4Gb SD card
1
view
2
comments
0
points
Most recent by
good_idea
February 2018
Repetier-Server
Heat heats slowly after emergency stop and reset with M999
1
view
3
comments
0
points
Most recent by
Repetier
January 2018
Extruder & Bed
turning on (even disconnected) hotend heater changes behavior of proximity sensor (1.0.0dev)
1
view
3
comments
0
points
Most recent by
good_idea
January 2018
Bug Reports
Is somewhere a renewable list of repetier (firmware) supported motherboards available? (-)
1
view
2
comments
0
points
Most recent by
good_idea
January 2018
Motherboard
M106 commands with P0, P1, P2 etc addresses to the same print cooling fan, not others
1
view
3
comments
0
points
Most recent by
good_idea
January 2018
Repetier-Firmware
How to add 5-th temperature-dependent (PWM) fan?
1
view
2
comments
0
points
Most recent by
good_idea
December 2017
Questions & Answers
Need to slowly heat up the bed not to break the glass - is it possible?
1
view
2
comments
0
points
Most recent by
good_idea
December 2017
Extruder & Bed
Missing Repetier Logo on icon & double clicking icon always starts dialog (run in terminal, dislplay
13
views
1
comment
0
points
Most recent by
good_idea
November 2017
Linux
Where to see third temp sensor value?
46
views
4
comments
0
points
Most recent by
good_idea
October 2017
General
Protect hardware from autoleveling sensor malfunction - keep Z-min endstop 2 mm below print surface
109
views
6
comments
0
points
Most recent by
good_idea
March 2017
General