Richard_Brown

Discussions

• Calibration cube with PLA and PETG. PETG is off 0.6mm in Y direction and 0.3 in X direction. Z is ok

  1 view 3 comments 0 points Most recent by Repetier September 2020CuraEngine
• layers not aligned. I make a small rectangle and the sides are at 45 degrees.

  1 view 7 comments 0 points Most recent by Repetier May 2020Questions & Answers
• TronXY with Melzi V2.05 hex file too big - what do you recommend I remove. Thanks

  1 view 48 comments 0 points Most recent by Repetier May 2019Repetier-Firmware
• Can Repetier 1.X be installed on a Melzi version 2.0.5 controller board for a TronXY 3S 3D Printer?

  1 view 2 comments 0 points Most recent by Richard_Brown December 2018Repetier-Firmware
• Melzi 2.0.5 Control Board and a TronXY 3X

  1 view 2 comments 0 points Most recent by Richard_Brown August 2018Questions & Answers