ziegelstein

Discussions

• Dev.2 + Repetier Server 1.03

  1 view 1 comment 0 points Most recent by Repetier January 2021Bug Reports
• Dev.2 Layer shift, Filament Sensor, Z-Bewegungen.

  1 view 14 comments 0 points Most recent by karl_ranseier March 2021Bug Reports
• Dev. 2 - Z Leveling

  1 view 1 comment 0 points Most recent by Repetier January 2021Feature Requests
• Dev.2 einrichten, Verständisfragen

  1 view 13 comments 0 points Most recent by ziegelstein January 2021General
• TMC2130 + Radds + 1.04/1.05 Firmware

  1 view 18 comments 0 points Most recent by Repetier January 2021Motor Control
• Mixing Extruder - Setup, Gewichtung wo einstellen?

  1 view 1 comment 0 points Most recent by Repetier May 2020Extruder & Bed
• watchdog reset - mögliche ursachen?

  1 view 7 comments 0 points Most recent by ziegelstein April 2020Motherboard
• 3 Extruder, alle an Jam Pin Y-min

  1 view 6 comments 0 points Most recent by ziegelstein April 2020Extruder & Bed
• Connection Cura to repetier Server pro

  1 view 8 comments 0 points Most recent by rivado November 2019Repetier-Server
• G30 G32 end in watchdog reset when z-probe is triggerd

  1 view 6 comments 0 points Most recent by Repetier October 2019Repetier-Firmware