jvbiondo

Discussions

• Is there a way to simulate the homed condition without motors and limits installed?

  1 view 3 comments 0 points Most recent by Repetier January 2023Motor Control
• Can I add a feature to the firmware to send a message when motors have stopped?

  1 view 4 comments 0 points Most recent by Repetier January 2023Motor Control
• Is There a Code To Read the State of GPIO Pins?

  1 view 9 comments 0 points Most recent by jvbiondo December 2022General
• Is there an Abort Current Move command?

  1 view 4 comments 0 points Most recent by jvbiondo November 2022Repetier-Firmware
• How to Z Probe and get value at a single point

  1 view 2 comments 0 points Most recent by jvbiondo July 2020General
• How can I command a single column's motor to move in a Delta printer

  1 view 7 comments 0 points Most recent by Repetier March 2021Motor Control
• How can I change boolean eeprom values with M206?

  1 view 2 comments 0 points Most recent by jvbiondo December 2019Questions & Answers
• Changing the XY Locations used during Z Probing

  1 view 2 comments 0 points Most recent by jvbiondo December 2019General
• What are the printer size limitations for Delta style printers

  1 view 5 comments 0 points Most recent by Repetier December 2019General
• Movements Along Positive Values of Y Axis of Delta Goes Extremely Slow

  1 view 2 comments 0 points Most recent by Repetier June 2019Questions & Answers
• Homing fails every other time G28 is entered

  1 view 2 comments 0 points Most recent by jvbiondo June 2019General
• Is there a way to enter ZProbe results manually for bed levelling on machine startup?

  1 view 1 comment 0 points Most recent by Repetier June 2019Questions & Answers
• Using Due Without EEPROM

  1 view 5 comments 0 points Most recent by jvbiondo June 2019Questions & Answers
• Compilation Error With Arduino 1.83, "sketch\HAL.h:34:20: fatal error: avr/io.h: No such file...

  1 view 2 comments 0 points Most recent by jvbiondo May 2019Bug Reports