jvbiondo
About
- Username
- jvbiondo
- Joined
- Visits
- 6
- Last Active
- Roles
- Member
Comments
-
Thank you, that worked!
-
Thank you for commenting on my issue. It certainly is not a big problem for me and I indeed fine tuned it by changing the steps in EEPROM and using a vernier calipers to verify the distance between the carriages and the bed at datum points I designe…
-
The reason I wanted to be able to do this was for Delta calibration. The suggested method of de-energizing a motor, moving it to a calibration point, and then re-energizing it suffers from the problem that when the motor is re-energized it moves sli…
-
Thank you for getting back so quickly.
-
Thank you again for your help.
-
Thank you.
-
Thank you very much for the quick answer.
-
I resolved the problem finally by starting completely fresh with the configuration tool and very carefully filling out each item.
-
Repetier said: You need to tell firmware to move back z after homing 10-20mm for deltas. At top you have no move place so even adjusting to rotation or tool position will trigger end stops. So if you go down after homing you can adjust withou…
-
jvbiondo said: Repetier said: There are only 2 ways for permanent storage - EEPROM or sd card. You can wire quite easy the eeprom chip to power and I2C pins as one possible solution. I would like to wire in the EEPROM as my preferre…
-
G
-
Repetier said: There are only 2 ways for permanent storage - EEPROM or sd card. You can wire quite easy the eeprom chip to power and I2C pins as one possible solution. I would like to wire in the EEPROM as my preferred solution. Would thi…
-
Repetier said: You need to select the right board in arduino ide or the file will not be there. Since it wants a avr file probably Mega 2560 board. Thank you for your quick response. I am using a Due in my project, but I may have made a mi…