Israel

Discussions

• Temperature curve display

  88 views 1 comment 0 points Most recent by Repetier December 2016Repetier-Host
• Actual print size of an object.

  100 views 1 comment 0 points Most recent by Repetier October 2016General
• Feed Rate VS Run Rate

  432 views 2 comments 0 points Most recent by Israel October 2016Repetier-Host
• wall around object

  63 views 2 comments 0 points Most recent by Israel September 2016Repetier-Host
• Weak prints

  205 views 5 comments 0 points Most recent by Repetier September 2016Repetier-Host
• Layer 2 no bonding with layer 1 (brim/ramp)

  126 views 4 comments 0 points Most recent by Repetier August 2016Slic3r
• Nylon print problems

  98 views 3 comments 0 points Most recent by Repetier August 2016Slic3r
• Extruder not feeding correctly

  418 views 10 comments 0 points Most recent by Repetier August 2016Extruder & Bed
• Y-axis center is off

  152 views 5 comments 0 points Most recent by Israel August 2016Slic3r
• G1 Z 0.400 F7800.000

  210 views 8 comments 0 points Most recent by Repetier August 2016Slic3r