karl_ranseier

Discussions

• DEV2: G30 / G32 z-probe height

  1 view 3 comments 0 points Most recent by Repetier April 2021Extruder & Bed
• DEV2: Homing if endstop is much more far away than expected

  1 view 2 comments 0 points Most recent by karl_ranseier March 2021Bug Reports
• DEV2: Bed leveling grid area wrong?

  1 view 19 comments 0 points Most recent by karl_ranseier April 2021Bug Reports
• DEV2: Clean installation not compiling

  1 view 5 comments 0 points Most recent by karl_ranseier March 2021General
• DEV2: Description of dead time heater

  1 view 20 comments 0 points Most recent by karl_ranseier November 2020General
• DEV2: G32 not working as expected

  1 view 25 comments 0 points Most recent by Repetier January 2021Bug Reports
• DEV2: M9999 after fatal state not allowed

  1 view 1 comment 0 points Most recent by Repetier October 2020General
• DEV2: DIR signal at low speed

  1 view 13 comments 0 points Most recent by karl_ranseier October 2020General
• Dev2: Cleanup of configuration.h

  1 view 2 comments 0 points Most recent by karl_ranseier October 2020General
• Dev2: G30 always homes first

  1 view 37 comments 0 points Most recent by karl_ranseier October 2020General
• Rumba32: Servo position at start and after "auto-off"

  1 view 2 comments 0 points Most recent by karl_ranseier October 2020General
• Homing confusing

  1 view 15 comments 0 points Most recent by Repetier October 2020General
• Homing not working as expected (does not stop)

  1 view 5 comments 0 points Most recent by karl_ranseier September 2020Motor Control
• Experience RUMBA32 installation (and upload problem)

  1 view 29 comments 0 points Most recent by karl_ranseier September 2020Repetier-Firmware
• Download Firmware V2 for RUMBA32

  1 view 4 comments 0 points Most recent by karl_ranseier September 2020Repetier-Firmware
• Software Reset during auto level

  1 view 9 comments 0 points Most recent by karl_ranseier September 2020General
• Oscillation on bed and nozzle temprature after auto bed levelling

  1 view 6 comments 0 points Most recent by Repetier March 2018Bug Reports