jim8541

Discussions

• G32 returns different Printer height than measured height

  35 views 3 comments 0 points Most recent by Repetier November 2017Questions & Answers
• Leveling Hot End to Print Surface

  47 views 1 comment 0 points Most recent by Repetier June 2017Questions & Answers
• Z probe Height versus Max. Z-probe-bed dist.

  99 views 1 comment 0 points Most recent by Repetier May 2017Repetier-Host
• PID autotune

  234 views 1 comment 0 points Most recent by Repetier February 2017Questions & Answers
• Z Probe Height

  495 views 12 comments 0 points Most recent by Repetier June 2017Repetier-Firmware
• PNP photoelectric NO Z-probe

  119 views 6 comments 0 points Most recent by Repetier December 2016Repetier-Firmware
• Do I always have to change EEprom bit #1 number to save config when I upload ?

  54 views 1 comment 0 points Most recent by Repetier November 2016Questions & Answers