opy01

Discussions

• Pi 5 USB camera not working

  1 view 10 comments 0 points Most recent by opy01 March 9Repetier-Server
• Repetier Server - Klipper input shaping with USB adxl345

  1 view 19 comments 0 points Most recent by opy01 February 29Repetier-Server
• Serious issues with my Repetier Pi

  1 view 4 comments 0 points Most recent by opy01 October 2021Questions & Answers
• Repetier Firmware on stock Ender 5 Plus

  1 view 15 comments 0 points Most recent by opy01 December 2020Motherboard
• X/Y probe offset not used when bed leveling

  1 view 37 comments 0 points Most recent by opy01 October 2020Questions & Answers
• Firmware retraction not working as expected

  1 view 2 comments 0 points Most recent by opy01 January 2020Extruder & Bed
• CR10s pro v2 connected but no control

  1 view 3 comments 0 points Most recent by opy01 January 2020Repetier-Server
• DUE/RADDS with ATX power supply cycles on/off continuously when not plugged into USB

  1 view 3 comments 0 points Most recent by Repetier September 2019General
• Ubuntu Mate USB Cam

  1 view 2 comments 0 points Most recent by opy01 August 2019Questions & Answers
• Print Rescue

  1 view 3 comments 0 points Most recent by opy01 July 2019General
• Print randomly pausing at retract

  1 view 7 comments 0 points Most recent by Repetier January 2019General
• ZHOME_X_POS and ZHOME_Y_POS not working

  1 view 5 comments 0 points Most recent by Repetier January 2019Extruder & Bed
• Firmware Retraction

  1 view 2 comments 0 points Most recent by opy01 October 2018Extruder & Bed
• Dual Z TMC configuration

  1 view 2 comments 0 points Most recent by opy01 July 2018Motor Control
• Tool Change Speed

  1 view 12 comments 0 points Most recent by opy01 May 2018Extruder & Bed
• New setup Z homing crashes into bed

  1 view 25 comments 0 points Most recent by opy01 April 2018Extruder & Bed
• 1.0.2 not working on my Mega 2560 and RAMPS.

  1 view 33 comments 0 points Most recent by Repetier December 2019General