mitch25

Discussions

• print stopping with error message "mintemp triggered"

  47 views 3 comments 0 points Most recent by Repetier September 2017General
• ABS print starts warping after 3 hours

  58 views 4 comments 0 points Most recent by JanComputerman September 2017Tips & Tricks
• Is my 5A polyfuse on my RAMPS board bad?

  19 views 0 comments 0 points Started by mitch25 August 2017 General
• Extruder and motors tripping fuse

  23 views 0 comments 0 points Started by mitch25 August 2017 Extruder & Bed
• Extruder polyfuse getting very hot and stopping print

  108 views 21 comments 0 points Most recent by RAyWB August 2017Motherboard
• extruder stops heating, and software keeps sending code.

  44 views 6 comments 0 points Most recent by mitch25 August 2017General
• extruder light goes off mid print

  23 views 2 comments 0 points Most recent by mitch25 August 2017General
• extruder heating up very slowly

  45 views 4 comments 0 points Most recent by MartinH August 2017General
• Extruder stops heating mid print

  36 views 4 comments 0 points Most recent by Repetier August 2017General
• Not able to start a print, errors showing up in my log on repetier.

  77 views 4 comments 0 points Most recent by mitch25 August 2017General
• Is my RAMPS board faulty?

  226 views 13 comments 0 points Most recent by Repetier September 2016Motherboard
• Connecting my stepper motor wires to RAMPS 1.4

  154 views 1 comment 0 points Most recent by Repetier August 2016Motherboard
• Extruder temperature reading 0 degrees Celcius on repetier.

  129 views 1 comment 0 points Most recent by Repetier August 2016Repetier-Host
• Power supply and motor driving for RAMPS 3d printer controller

  63 views 1 comment 0 points Most recent by Repetier August 2016Motherboard
• 3D printing stepper control, Temperature measurement and control without RAMPS.

  74 views 1 comment 0 points Most recent by Repetier August 2016Motherboard
• What are Ramps pins on my arduino mega pins

  234 views 2 comments 0 points Most recent by Repetier August 2016Repetier-Firmware