Hallo!

Recently, I uninstalled my RH firmware and reinstalled version 2.3.2.  I can't connect to my FT3, and I keep getting the same error message "The Semaphore period has timed out"...I've tried…

I see 2 things. Problem onw seem

Hello. I installed Ubuntu and Repetier Server on my Orange Pi Zero 3. I loaded the backups of the 3D printers that I had on another Orange Pi and set everything up. However, the problem I'm having is…

Wondering, with 3 Extruder (E0, E1, E2) same temp zero sensor and same Heater E0 and if having all the same for each should be E1 and e2 Different?

used the Config tool keep getting errors during compile with either tool says problem temp pin 3 which is an easy fix i have 3 extruders should be temp 1 heater o

Hello there!

Okay, got ya.

I did not mean to look into eeprom source, I meant in  Repetier-Server or Host to open eeprom editor to see which values are stored for offset etc.

Okay, first i deactivated line 310 #define ENDSTOP_Z_BACK_ON_HOME 0. It issued a so called: "Compilation error: 'DIOFAN2_PIN_WPORT' was not declared in this scope"

In that case there was an error during upload of the zip files from backup. Can be a simple network error or something else. Of it happens again at same place check the server.log or look in troubles…

I GOT iT!  The pins I had in the original post were correct.  I flashed the adxl345 on my other Pi with a different version of Klipper.  I finally found an error message I could use lol.  I created a…

I thought the input calibration was fixed in the image already. Seems I have it only for next image release coming soon.

Ok I am going to try V36 tomorrow.  Not sure if something is just flaky with V37 since it is set up for the Pi 5.  Hoping that's all it is.  I put my old SD card back in and am up and running again, …

So, my printer worked perfectly today, and while it was printing, it suddenly stopped. Out of nowhere, it disconnected and when i tried to connect it, i got the error "The given port name does n…

Et pour couronner le tout impossible de m’être à jour.

You clearly see perimeter not touching each other always and top infill not solid, so you are still under extruding! Increase extrusion factor and see if it gets better. Error can easily be 10-20%. 

Same problem here. Im trying to install klipper but this fails and now cant delette printers.

Hi i updated klipper in repetier-server. Then i tried to install the input shaper and got an error.

And again myself:-)