-
Bad value for Z counter, after G28
by Grezco ·#include "pins.h"// ################## EDIT THESE SETTINGS MANUALLY ################ -
MKS Rumba mit TFT "Checksum Error"
by Bonobo ·#include "pins.h" -
Laser enable pin issue
by ChicoCybergoth ·#include "pins.h" -
RepRapD1scount Smart Controller
by silver1882 ·#include "pins.h" -
Mirrored Extruder spins with Z on Home and Raise
by RandalZimmer ·#include "pins.h" -
Z axis not moving at all on COREXY
by Bleachworthy ·#include "pins.h" -
1.0.4dev homing problems -CR10S (Crealty 2.1 board)
by badvision ·#include "pins.h" -
Afinibot A3 upgrade problems
by jonarotz ·#include "pins.h" -
Linear advance extruder stops
by overdrive ·MOTHERBOARD 999 #define RFSERIAL Serial #include "pins.h" // ################## EDIT THESE SETTINGS MANUALLY ################ // ################ END MANUAL SETTINGS ############### -
No voltage output on D10 pin while G1/G2/G3 command in laser mode
by rdzawka ·#include "pins.h" -
Print randomly pausing at retract
by opy01 ·#include "pins.h" -
BLTouch not working
by neoh ·#include "pins.h" -
MABL mit BL Touch
by Bonobo ·#include "pins.h" -
Problem using 3 Z steppers and bed leveling
by bryanbdp ·#include "pins.h" -
problem with firmware
by j_tmec ·#include "pins.h" -
Heated bed not working
by CSchiavoni ·#include "pins.h" -
2 problems. need help
by allen_g30 ·#include "pins.h" -
Extruder motor won't run when plugged into E0
by CSchiavoni ·#include "pins.h" -
Nozzle does not extrude filament
by recaizade ·#include "pins.h" -
Integration of RADDS2LCD
by Repetier ·1. Bedingt. Nur die #include anweisungen sollte man nicht überschreiten, weil da extra code eingefügt wird. Ansonsten gibt es denke ich keine abhängigkeiten. Aber es sollte klar sein das dass Config T