Mirrored Extruder spins with Z on Home and Raise
Hi, I run two extruders to double my output using a RamBo board. When first connecting, (when up to temp) and I extrude, only #0 spins. Once I start a print, the #1 extruder spins and continues to mirror until disconnected. The same with manually heating, I need to click both extruders on startup but after a print is started, the control mirrors. Both of those I can deal with but my real problem is that when I home the Z, the #1 (mirrored) extruder spins in retraction direction When raising Z, it extrudes. The only thing I can't have is the retraction. It pulls hot plastic up and clogs. (I use pellet extruders and the pellets form a ring new pellets can't get past). Is there any way to disconnect Z from #1?