DBSDBS
About
- Username
- DBSDBS
- Joined
- Visits
- 200
- Last Active
- Roles
- Member
Comments
-
I understood. Thanks.
-
Unfortunately I haven't any other free pin, because I have LCD display I use Arduino Mega 2560 + RAMPS 1.4 + LCD 16*4) The only free pins are ENDSTOP pins, SERVO pins and Aux 1 to 3 (on the RAMPS 1.4) Any advice?
-
I'm totally confused... Yesterday I made a "movable" Z probe, because I have no time now to make a version with servo. What I made:1. Switched OFF "Z min endstop";2. Connect the Z probe to "Z max endstop" pin and assigned it in a firmware.; (I have …
-
Thank you for the reply. I read many of them, but as you told almost every one made self version. By me it will be good if somewhere in the Repetier site are posted for example links with good working decisions with pictures and schematics for majo…
-
Thank you!
-
Thanks for the info. This is usable, but my idea was to tell to Repetier "That is my Z0" when I do initial homing. What I mean: At the beginning I check Z0 by paper sheet. After than I lift Z to 10mm (Z10). Then I tell the printer: Home X, Home Y an…
-
Hi, I write here, because my problem is almost the same.... I measured the real temperature in the hole of the screw for the nozzle. The real temperature was 209° instead of 239°, measured from Repetier. I'm sure that the type of the thermistor is a…
-
Thank's again!
-
Thank you very much! All is OK now.
-
YES..... the "magic" is in "Eeprom settings"... Thank you very much! All is OK now. Just one question: Where from / to / the Host get / put / this settings, and why they stay even if a new skatch is loaded? Best Regards
-
Thank's I'll do this and will report the results.
-
#define ENABLE_BACKLASH_COMPENSATION 1#define X_BACKLASH 0#define Y_BACKLASH 0.22#define Z_BACKLASH 0 This is from a Configuration.h
-
Thank you for the reply. It does not mater what is the value in "xMinPos" and "yMinPos". Now they are respectivelly: 35 and 15. But even if they are 0, no diference.I searched all the Configuration.h , but the value of 240 I found just for the ABS e…