sshneider

Comments

• Cool!  THANK YOU!!!!!!!!

  in G or M Code for Flowrate? Comment by sshneider December 2017
• I believe you but, it doesn't make sense what you are saying.... If Repetier Host ONLY shows ETE in Hours Mins & Secs then what is converting these hours into a Solar Time (i.e. 10:24 PM)?  Whatever... I really don't care- Can yo just fix it ple…

  in Progress Update message shows Estimated Time of Completion Only??? Comment by sshneider December 2017
• So... it's been over a month since I posted this simple request.  I have noticed that a few days ago that Repetier Informer was updated via Google Play however, this issue has not been addressed. As previously mentioned Informer reports when a prin…

  in Progress Update message shows Estimated Time of Completion Only??? Comment by sshneider December 2017
• I think what we have here is a failure to communicate.... I know exactly what informer is (& what it is not LOL).  I don't think that you are understanding me?  I do not think that the user(s) has anything at all to do with my request since th…

  in Progress Update message shows Estimated Time of Completion Only??? Comment by sshneider October 2017
• I use Host. Don't really under stand what your saying? When informer sends a status update message it states the rest. Time of completion but NOT the date... If the print is more than 24hrs away from completion then this time estimate is unclear as …

  in Progress Update message shows Estimated Time of Completion Only??? Comment by sshneider October 2017
• Uh... with all due respect, you didn't address my question... Can you add the date to the estimated completion time that informer pushes? Thanks

  in Progress Update message shows Estimated Time of Completion Only??? Comment by sshneider October 2017
• Ah, OK.  Thank you

  in Add M600 - Filament Change to notifications Comment by sshneider October 2017
• Hmmmm I'm not sure I understand.  Could you please clarify? First, I do have the Informer set to activate on fatal errors. In my opinion, M600 is NOT technically a fatal error and it's kinda wonky that you guys decided to group it in that category.…

  in Add M600 - Filament Change to notifications Comment by sshneider October 2017
• I'm using Repetier Host ver 2.0.5 , Marlin Firmware (it's way old though ver 022)  - perhaps that's my problem??? When the Filament monitor sees a fault condition, it enques a M600 command.  Enque is OK I guess but, it's slow/not immediate because t…

  in Add M600 - Filament Change to notifications Comment by sshneider October 2017
• Awesome!  Thank You!

  in Current G-Code listing Comment by sshneider October 2017
• And where would one find this Repetier.ino file please?

  in Current G-Code listing Comment by sshneider October 2017