›

G or M Code for Flowrate?

sshneidersshneider
in Repetier-Host
is there a G or M Code that will control/vary the flow rate setting in Repetier Host? It would be a welcome function as it would allow users to change flow rates for different layers.

Thanks

Comments

  • RepetierRepetier
    You can use M221 S<percent>
    Host also has this as slider if easy mode is disabled. Only requirement is that firmware understands it but nearly all do.
  • sshneidersshneider
    Cool!  THANK YOU!!!!!!!!
Sign In or Register to comment.