-
COREXY dual X-Carriage
by 0xmarcelx0 ·#undef FAN_BOARD_PIN -
problem with bluetooth serial
by ronix3 ·#undef ENDSTOP_ZMAX_PIN //clear zmax pin for serial -
Laser Not Turning Off When Print is Running
by jm757 ·#undef FAN_PIN -
problem with bluetooth serial
by ronix3 ·#undef ENDSTOP_ZMAX_PIN //clear zmax pin for serial -
X2 motor doesn't move in IDEX
by Repetier ·#undef FAN_BOARD_PIN -
G30 G32 end in watchdog reset when z-probe is triggerd
by ziegelstein ·#undef FAN_PIN -
second UART for Bluetooth isnt working after upgrade from 0.9.2 to 1.0.1
by gepardya ·#undef EXTERNALSERIAL -
Dual extruder X Y offset
by klaus ·#undef FAN_PIN -
Bad value for Z counter, after G28
by Grezco ·#undef FAN_BOARD_PIN -
Radds SD Card
by Vitja ·#undef SDSS -
Radds SD Card
by Repetier ·#undef SDSS -
MKS Rumba mit TFT "Checksum Error"
by Bonobo ·#undef FAN_BOARD_PIN -
Laser enable pin issue
by ChicoCybergoth ·#undef FAN_BOARD_PIN -
RepRapD1scount Smart Controller
by silver1882 ·#undef FAN_PIN -
Mirrored Extruder spins with Z on Home and Raise
by RandalZimmer ·#undef FAN_BOARD_PIN -
Z axis not moving at all on COREXY
by Bleachworthy ·#undef FAN_BOARD_PIN -
1.0.4dev homing problems -CR10S (Crealty 2.1 board)
by badvision ·#undef FAN_BOARD_PIN -
Afinibot A3 upgrade problems
by jonarotz ·#undef FAN_BOARD_PIN -
Linear advance extruder stops
by overdrive ·MANUAL SETTINGS ########################## //#undef FAN_BOARD_PIN //#define FAN_BOARD_PIN -1 //#define BOARD_FAN_SPEED 255 //#define BOARD_FAN_MIN_SPEED 0 //#define FAN_THERMO_PIN -1 //#defin -
sd card does not work no 1.0.2
by csmith ·#undef SDCARDDETECT