-
Radds 1.6 or due not initializing/booting correctly on 1.0.2
by ZibbeZabbe ·MOTHERBOARD 402 #define RFSERIAL SerialUSB #include "pins.h" // ################## EDIT THESE SETTINGS MANUALLY ################ #define MICROSTEP_MODES { 16,16,16,16,16,16,16,16 } // -
How to setup 2 in 1 out HE3D K200 to print 2 colours
by Giomlyon ·#include "pins.h" -
Repetier Firmware 2 Lüfter für Bauteil ansteuern
by Hobbit ·#include "pins.h" -
EXTn_JAM_PIN missing in configuration tool
by furynick ·MOTHERBOARD 402 #define RFSERIAL Serial #include "pins.h" // ################## EDIT THESE SETTINGS MANUALLY ################ // ################ END MANUAL SETTINGS ############### -
CNC Mode Freezing up
by mystique ·#include "pins.h" -
COREXY dual X-Carriage
by 0xmarcelx0 ·#include "pins.h" -
minimize cable to extruder
by tgreif ·#include <Wire.h> -
Laser Not Turning Off When Print is Running
by jm757 ·#include "pins.h" -
X2 motor doesn't move in IDEX
by Repetier ·#include "pins.h" -
G30 G32 end in watchdog reset when z-probe is triggerd
by ziegelstein ·#include "pins.h" -
Dual extruder X Y offset
by klaus ·#include "pins.h" -
Bad value for Z counter, after G28
by Grezco ·#include "pins.h"// ################## EDIT THESE SETTINGS MANUALLY ################ -
MKS Rumba mit TFT "Checksum Error"
by Bonobo ·#include "pins.h" -
Laser enable pin issue
by ChicoCybergoth ·#include "pins.h" -
RepRapD1scount Smart Controller
by silver1882 ·#include "pins.h" -
Mirrored Extruder spins with Z on Home and Raise
by RandalZimmer ·#include "pins.h" -
Z axis not moving at all on COREXY
by Bleachworthy ·#include "pins.h" -
1.0.4dev homing problems -CR10S (Crealty 2.1 board)
by badvision ·#include "pins.h" -
Afinibot A3 upgrade problems
by jonarotz ·#include "pins.h" -
Linear advance extruder stops
by overdrive ·MOTHERBOARD 999 #define RFSERIAL Serial #include "pins.h" // ################## EDIT THESE SETTINGS MANUALLY ################ // ################ END MANUAL SETTINGS ###############