#2  0x00000000005c34ef in ?? ()

Hey all, I have a Geetech MeCreator 2 printer that uses Marlin firmware. I'm trying to switch it over to repetier firmware since all my other printers use repetier. I'm more familiar repetier so when…

Flow multiplier for filament ? Is it from memory or software?

first entry.  It always results in only stepper #2 being the only one turning.  BTW, I think the term extruder should be used less often, since with mix-hotends and shared-hotends, the definition of

In my test cases, I am using 0/1 and 1/0 ratios for the test virtual extruders, so I can easily see what is being driven.  When I ran my quick test print with no filament, it behaved as before, when I

Yeah, the subfolder topic leads me to another "idea" (rather a paradigm shift): groups are nice, but somehow limited. A hierachy would be more suitable in some cases which I fake by using s…

* I haven't figured out why similar commands give quite different results.  I used the LCD Position menu, the Repetier host manual Control buttons, manual G1 commands, and their "Home Z" equ

When I print with extruder #1, it prints very well. It needs some very very minor tweaks, but it prints well. When I TRY to print with extruder #2, it heats the bed only to 50c, it doesn't heat the ho

#2:

I'm  using Smoothieboard /Smoothieware and switching from Pronterface

Has anyone had problems with the printer becoming disconnected from repetier in a few seconds of a print?

#2 TEST: 45mm however just before this point the motor started slowing down for the last 5mm falling short of 50mm

#2  0x00000000005ad8b9 in finalizer_thread ()

I finally got to print with the right extruder last night (once). Every slice (with sli3r or cura) goes to the left extruder. #2 is selected in the Object Group menu, slic3r slices it and shows the #2

I have tried connect fan 1 in the first fan port to? but nothing happens?

I might have found situation it happens.

- Print job sent to printer for single extruder so extruder #2 is turned off and the print starts.

#2

ok thanks but in don't understand this because If you build or upgrade your printer with/to DUAL-EXTRUSION (2 extruder) including a heated bed all the output ports (D8,D9,D10) will be used. In this c…

Hi at all I have some questions.