if thefirmware == '': #if thefirmware == 'Repetier_1.0.3': print('Execute startup GCODE ...') for thecmd in theCMDs: time.sleep(0.5) print('Send

#if defined(DOOR_PIN) && DOOR_PIN > -1

#ifndef CONFIGURATION_H

Adding new systems to V1 firmware is a bit of a pain as there are so many things to consider. A much better solution would be to directly start with V2 firmware. There each motion system consists of a

#if JSON_OUTPUT

                  #if DRIVE_SYSTEM==DELTA || DRIVE_SYSTEM==TUGA || DRIVE_SYSTEM==BIPOD || defined(FAST_COREXYZ) || defined(CABLE_ROBOT) 

#ifndef CONFIGURATION_H

#ifdef RAMPS_V_1_3

#ifndef CONFIGURATION_H

#ifndef CONFIGURATION_H

<http://www.gnu.org/licenses/>. */ #ifndef CONFIGURATION_H #define CONFIGURATION_H /**************** READ FIRST ************************ This configuration file was created with

#if HOST_RESCUE

#ifndef CONFIGURATION_H

#ifndef CONFIGURATION_H

#ifndef CUSTOM_CONTROLLER_PINS

#ifndef CONFIGURATION_H

#if defined(SUPPORT_LASER) && SUPPORT_LASER

#ifndef SDSUPPORT  // Some boards have sd support on board. These define the values already in pins.h

#ifdef RAMPS_V_1_3

#ifndef SDSUPPORT  // Some boards have sd support on board. These define the values already in pins.h