danikurnianto

Discussions

• What gcode to have a motor run automatically when an 'end-stop' get triggered ?

  1 view 1 comment 0 points Most recent by Repetier January 2018Questions & Answers
• how to setup MKS MINI12864LCD

  836 views 3 comments 0 points Most recent by snegs February 2017Display & Keyboard
• what is the Gcode to run 2 extruder motors in the same time?

  168 views 6 comments 0 points Most recent by danikurnianto September 2016Questions & Answers
• Repetier Host manual control for extruder issue

  2.2K views 13 comments 0 points Most recent by Repetier October 2015Questions & Answers
• RequestPause:Homing failed! message and weird coordinator during Bed Height map

  486 views 5 comments 0 points Most recent by Repetier July 2015Questions & Answers
• Delta endstops offset calibration with a stick/rod before doing autolevel G32

  143 views 3 comments 0 points Most recent by Repetier July 2015Questions & Answers
• Host v1.5.0 is missing the 'G-code dropdown'?

  306 views 2 comments 0 points Most recent by Repetier July 2015Questions & Answers
• How is setting up an Always-doing an automatic-bed-leveling everytime prior the printing started?

  1K views 10 comments 0 points Most recent by danikurnianto July 2015Questions & Answers
• Changing value through the configuration tool VS value in the EEPROM (showed in the host)

  135 views 1 comment 0 points Most recent by danikurnianto June 2015Questions & Answers
• Dual extruders with their own offset X and Y on Delta system, what best home position strategy?

  306 views 1 comment 0 points Most recent by Repetier June 2015Questions & Answers