ap742

Comments

• and word on this ? 

  in How do I flash da Vinci 1.1 plus with repetier? Comment by ap742 October 2016
• grinned off notches on cable flip them around and bang works :-) back to printing :-)

  in MKS Gen 1.4 step by step Comment by ap742 August 2016
• I have to keep retraction speed at 0 if I don't i'll retract filament back way too much so infill starts laying half way into it.  maybe I got something wrong somewhere in the settings but 0 works great except ETA time always stays at -55:-(

  in The estimated time in repetier shows up negative Comment by ap742 August 2016
• okay it is slicer at least it was for me.  under Retraction Speed: set to 0 

  in The estimated time in repetier shows up negative Comment by ap742 August 2016
• did any one resolve this ?  got same thing .  ETE -55s under slicer Preview estimated printing time -8s  I think it has something to do with slicer not sure what tho

  in The estimated time in repetier shows up negative Comment by ap742 August 2016
• I would love to use Repetier as I did with da vinci .

  in MKS Gen 1.4 step by step Comment by ap742 August 2016
• ad this point I would take any firmware that will work. ....

  in MKS Gen 1.4 step by step Comment by ap742 August 2016