› ›

NickRno77

About

Username
NickRno77
Joined
Visits
22
Last Active
Roles
Member

Comments

  • @Repetier Sorry I should have created a new post. I updated using the Pi Screen auto updater. Just to make sure the deb file for downgrade is Linux 32 bit ARM (armel): libc 2.13 like on Raspberry-Pi Raspian. I also can’t…
    in Seit Update 1.0.2 - Communication Timeout Comment by NickRno77 January 2021
  • I have similar issues since updating to V1.02, how can I roll back to 0.94.3 please, ? 0.94.3 was solid for me. I have Prusa Mk3s and Rasberry Pi 3b
    in Seit Update 1.0.2 - Communication Timeout Comment by NickRno77 January 2021
  • Repetier said: The rumba einsy would be a mega 2560 compatible board. So if it works then with that setting. I was having trouble flashing the latest Prusa FW so the your FW Uploader saved me a lot of trouble. I new the Prusa had a Einsy B…
    in Flash Prusa MK3S firmware using Repetier-server Comment by NickRno77 September 2020
  • Repetier said: Have a look at this website it explains how to do it. Different webcams have different possible parameter. https://www.kurokesu.com/main/2016/01/16/manual-usb-camera-settings-in-linux/ Once you have the command to change them …
    in XYZ Control Speed and WEBCAM Comment by NickRno77 September 2020
  • cosmith71 said: I had this same problem.  Try this instead. M115 U3.7.2; tell printer latest fw version G90; use absolute coordinates M83; extrude relative mode M104 S [first_layer_temperature]; set extruder temp M140 S [first_layer_bed_…
    in Rendering the Gcode image too small Comment by NickRno77 September 2020
  • Repetier said: Normally that is http://ip:8080 or what ever port it was assigned. So just the beginning of the url you entered as webcam url with your ip instead of localhost. I did try that yesterday but didn't work but does now thanks.  …
    in XYZ Control Speed and WEBCAM Comment by NickRno77 September 2020
  • Repetier said: 1) It is defined in printer settings->General->Manual Control. Enter the speed you like there. 2) You can use the mjpg_streamer url manually. It has a web interface allowing to change some values. You can also add the set…
    in XYZ Control Speed and WEBCAM Comment by NickRno77 September 2020
  • cosmith71 said: After 3 days and 1 broken screen, I finally got the HyperPixel working on a Pi 4 with Repetier-Server. It turned out to be a simple fix.Note, I'm using a wired Ethernet connection.Flash Repetier-Server to an SD card. Add an em…
    in Repetier Server with Hyperpixel 4 touchscreen? Comment by NickRno77 September 2020