› ›

baradov

About

Username
baradov
Joined
Visits
3
Last Active
Roles
Member

Comments

  • yeah you right  i ve solved it it was a short due to a fried optocoupler on my custom shield  everything is running fine now thanks @Repetier
    in problem with homming and manual control Comment by baradov December 2018
  • thank you @Repetier also to mention my drivers are always enabled through a external wires on (ena + @12v) i am using M542 stepper drives(im using big steppers of 5a/phase) and yes all the axis are mirrored in configuration.h for my problem i found…
    in stepper not working Comment by baradov December 2018
  • hello i know it a late reply but if you still need help 10A/phase is a huge number since i dont know the specicaton of the stepper ut what i have in mind is the ma860 stepper drive itcan run on dc and ac ( 110 vdc and 80 vac ) and a curent per phase…
    in Help Finding Drive for Stepper Motor Comment by baradov December 2018
  • thank you very much @Repetier
    in userpins.h confusing Comment by baradov December 2018
  • Repetier said: userpins.h should only contain what a board definition otherwise would contain, like this: #define KNOWN_BOARD #define CPU_ARCH ARCH_ARM /***************************************************************** * Arduino Due Pin Assi…
    in userpins.h confusing Comment by baradov December 2018