sz3bbylA
About
- Username
- sz3bbylA
- Joined
- Visits
- 11
- Last Active
- Roles
- Member
Comments
-
thank you One more question please !!! I DON'T understand how to put machine from printer mode in laser mode !!! I don't find any information's about in firmware is posible to put machine in laser or in printing mode after compile and upload the…
-
I would like to know how can use my laser more efficient than PWM I use Repetier 1.04 firmware arduino due RADDS 1.5 I activate in firmware laser module but i don't understand how to activate this in firmware, in repetier-server in repetier-host , …
-
thank you can I change that value to make it float ? i would like to transform value in float but i don't know which files must be modified for this or which pin to use in repetier to have a large frequency for my laser I use arduino due radds 1.5
-
but if i set PDM instead of PWM ?
-
I don't use it in laser mode , I just want to know if fan accept values with decimals like in example
-
ok, fixed, the jack on extruder was in opposite direction on controller. but one think remain unclear for me with jack in opposite direction means red is in black and blue in green, that means the motor must spin in opposite direction but i was sur…
-
I already done this, I hear motor but not spinning, look like I have one coil in opposite directions, I will check again this but connection was taken from old mega + ramps and fit in radds+due Arduino
-
#ifndef CONFIGURATION_H#define CONFIGURATION_H /**************** READ FIRST ************************ This configuration file was created with the configuration tool. For that reason, it does not contain the same informations as the original Con…
-
config
-
unfortunately when i write firmware some month ago from an raspberry pi with an old arduino software work perfect and was no problem with endstop's i tried after to write the same firmware with arduino 1.8.5 and happend this but I quit that and i …
-
sz3bbylA said: this is my configuration.h thank you
-
this is my configuration.h thank you
-
no with old arduino software like that from raspberry pi (i think is 1.6) compiled is working correctly if i compile with new one 1.85 is happend this also i can not compile new version of repetier 1.02 on raspberry pi because of fat file problem a…
-
new settingsafter m0re research: ALWAYS_CHECK_ENDSTOPS 0 STEPPER_HIGH_DELAY 1 DIRECTION_DELAY 0 DOUBLE_STEP_DELAY 1 look ok now steppers look warm but around 40 degree after 2 hour printing I still don't find Overheat protection of drivers thank y…
-
I just arrived at Delay stepper high signal - 3 Delay stepper direction signal - 6 and happened the same thing - in the middle of printing just move with half of peace distance in one direction and broke my print steppers are 57BYGH115-003B WANT…
-
ok, you right I got ramps 1.4 8 bit on my controller controller say: t1 - time spend to activate enable pin t2 - after dir is activate is time till begin pulse on motor steps t3, t4, pulse time (pulse on pulse off) a. t1: ENA must be ahead of DIR…