Plodmore
About
- Username
- Plodmore
- Joined
- Visits
- 8
- Last Active
- Roles
- Member
Comments
-
Thanks. As I am on the downwards slide to extreme daftness. Would it be better then to slice in Cura XXX, load the gcode in Repetier Host then print via Repetier? Or when you say not compatible would the sliced model default to those elements of Cur…
-
Clearly overthinking it OK will try that, Thanks.
-
Thanks. Will have a look. Layer currently set 0.2mm against and extruder of 0.4mm. Will re-run at 0.1mm.
-
Thanks
-
Yup but even after homed they revert to flashing. should I be sending some command for the home settings to be stored?
-
I know the firmware has uploaded as I use a different printer name to display each time. Any thoughts on why the steps/mm in the configuration.h file don't = the ones Repetier M501 reports from the printer?
-
Ah. Would that be why my uploaded configuration.h files steps/mm are not the same as the printer says they are? I used Repetier to move the axes as part of the calibration process, updated the XYZE steps/mm in the configuration.h file and uploaded t…
-
Updated Configuration.h (worked as the custom name on panel is same as I requested). Repetier M501 & Marlin menu both show X192.47, Y101.55, Z400.90, E115.61. Marlin configuration.h however is set to X100, Y100, Z400, E100. Don't know if this …
-
Can you advise if this was sorted. I have same issue with Repetier Host 2.05.