streetwye
About
- Username
- streetwye
- Joined
- Visits
- 62
- Last Active
- Roles
- Member
Comments
-
Thank you very much for the help. I am a little slow sometimes, but I catch on slowly. It took a few deleting of thins but I got it. Now I have to figure out how to us it and what all it does.
-
When I use my printer server I can't get into change my settings.
-
SHIT!! I'm not a drinking man but I'm about to start. Thanks anyway.
-
Could you please give me a good set of settings to use. I'm going nuts trying to figure them out. The ones I have been using are above. I turned off the ooze setting. Now the outside edges are rough.
-
-
-
-
-
-
But there is still a gap between the sides. It's hollow.
-
The sides are not connected to the inside fill. I can pull the sides apart from the fill. It's like it is 2 peace's instead of 1.
-
streetwye said:
-
-
Here is what I am talking about. The sides are not attached.
-
Now what? I didn't change anything.
-
-
-
Is the server down. I cant get on it now.
-
I finely got it to work!!!!!!!!!!!!!!!!! Oh happy day!!!!!Not I need to figure out how to get my 3D Touch working. Any ideas?
-
I keep getting error "exit status 1". I get that no matter what version I use. What is going on!!!!!!
-
So what do I do? Is that why it will not verify?
-
-
Why do I keep getting this message !!!!!!
-
-
What is the best version to use?
-
I have been thinking, frightening I know. But could it be the version of Arduino I am using?
-
Please excuse that I'm a little slow. I am trying to understand this stuff. I cant read instructions and understand them. I have always been that way. I have tried the Arduino site to learn, but no use. If I see it I can get it. I have been trying t…
-
It has a MKS Base V1.4. Does that help? or should I get a different board? I'm about to lose what little mind I have. I also have a Ramps V1.4 but I cant seem to get it working either.
-
How would I go about fixing my firmware for my Tevo Tarantula? The Tevo site has a firmware, but it will not compile so I can load it. Any suggestions. I have had this printer over a month and have not been able to print anything yet.
-
Thank you very much. It's not easy to find someone to really help.