jszxwcq
About
- Username
- jszxwcq
- Joined
- Visits
- 23
- Last Active
- Roles
- Member
Comments
-
Thanks Martin, it works.
-
Thanks for all your support, I'm using board Ramps1.4, I'll test more, and tell you if someting else found. Thanks again!
-
I found the problem, there is a "STEPPER_INACTIVE_TIME", I set the time 15s, so when each movement finished, after 15 seconds, the AXIS is released, and the temperature inforamtion come. Now I set the "STEPPER_INACTIVE_TIME" 0s, ok now. But it is …
-
where can I disable autoreport temperature feature? thanks!
-
Thank you for the quick reply, I just tried, #define PAUSE_START_COMMANDS "G28 X0 Y0", still didn't work. I'm wondering if this function is only supported by Repetier Host? Can it be supported by sending comand "M25", or where might by the problem?
-
Thanks so much, it works.
-
OK, thanks for your quick reply.