batonio

Thanks a lot of. Everything are clear now. Best Regards

in Moving probe Z-up is vey slow Comment by batonio February 2019

Another question is, I want first layer adhesion correct in order ABS touch PolyCarbonate and avoid warping, with G32 S2 in a 35x35 matrix I get an 160x160mm square first layer of ABS quasi perfect. So I thought, if I mix G32+G33 i can get perfect …

in Moving probe Z-up is vey slow Comment by batonio February 2019

Hi again, I have changed Z homing Feed Rate in order to get more velocity in Z up movements with G32 command but velocity don´t improve. For example in a grid of 35x35 I need two hours and 30 minuts. Have you any idea in order to improve this in ve…

in Moving probe Z-up is vey slow Comment by batonio February 2019

Thanks a lot of. Trying to use a polycarbonate surface heatBed for printing ABS and heatBed heat distort a little the surface, but automatic bed levelling is making the magic.

in Moving probe Z-up is vey slow Comment by batonio February 2019

batonio said: GMTYDetectar idiomaAfrikáansAlbanésAlemánAmháricoÁrabeArmenioAzeríBengalíBielorrusoBirmanoBosnioBúlgaroCamboyanoCanarésCatalánCebuanoChecoChichewaChino simpChino tradCincalésCoreanoCorsoCriollo haitianoCroataDanésEslovacoEsloven…

in Moving Manual Z in FW 1.0.3 Comment by batonio February 2019

GMTYDetectar idiomaAfrikáansAlbanésAlemánAmháricoÁrabeArmenioAzeríBengalíBielorrusoBirmanoBosnioBúlgaroCamboyanoCanarésCatalánCebuanoChecoChichewaChino simpChino tradCincalésCoreanoCorsoCriollo haitianoCroataDanésEslovacoEslovenoEspañolEsperantoEsto…

in Moving Manual Z in FW 1.0.3 Comment by batonio February 2019

Correct. I run G92 Z30 after G1 S1 and the FW worked like 0.92.9. I can down the z axis suppose the same apply to x axis and y. Where is target position check via web configuration? or is possible via G1 S1 command only Thanks a lot of this behavo…

in Moving Manual Z in FW 1.0.3 Comment by batonio February 2019

Thanks a lot of. It worked like a champ

in Disabling in Configuration.h DECOUPLE_TEST ???? Comment by batonio October 2016

Thanks a lot of.I have read this phrase sometime in anothers threads but there is no parameters in configuration.h .So I have arrived to conclusion the line to modify in Configuration.h is this #define EXT0_DECOUPLE_TEST_PERIOD 12000 #define EXT0_D…

in Disabling in Configuration.h DECOUPLE_TEST ???? Comment by batonio October 2016

Thanks a lot of.I think i must do a proof of concept and ask again with the first results. Best Regards

in New Feature Request ? Or is implemented Comment by batonio May 2016

Hi I have tried development branch config tool, but I don´t see the full configuration for X1 Axis. I am naming "X1 axis" to axis X driving extruder 1 or Tool 1 In short : 1) I am using Repetier-Firmware version 1.0.0 dev 2) Mechanics --> X axis…

in New Feature Request ? Or is implemented Comment by batonio May 2016

Thanks a lot of. Just what I wanted. I´ll try this evening. You have coded on the fly my suggestion, very professional. Dont doubt I´ll do a donation and recommend your software in forums about CNC where I participate. My next adventure will be dual…