gassiebernal

Comments

• could instead a servo motor be a small stepper??

  in Tilting mechanism for dual hotend on a Delta printer Comment by gassiebernal May 2017
• super quick response. you guys rock!!fixed problem

  in prints come out mirrored form start Comment by gassiebernal May 2017
• thanks, found rare cartridge fail....changed to PID control and new cratridge ..it is all going super well , thanks

  in My hot end suddenly stops heating and decouples Comment by gassiebernal May 2017
• in My hot end suddenly stops heating and decouples Comment by gassiebernal December 2016
• Thanks for reply! I found that the pololu x drive was set at 5 amps and the rest to 1.4 amps. So I adjusted variable resistor to 0.9 amp in passive state to all of the driver's which when homing deliver 1.6 amps and printer working like a charm!

  in x stepper keeps going up Comment by gassiebernal April 2015