stevo1957
About
- Username
- stevo1957
- Joined
- Visits
- 8
- Last Active
- Roles
- Member
Comments
-
By way of update: I turned on the Pi this afternoon and it booted up to V 1.4.1 I don't know why, given that yesterday I had no success whatsoever the last 4 or 5 times I tried rebooting the newly created 1.4.1 image. I backed up my Pi 1.3.1 ve…
-
This is strange.... I obtained another SD card, reformatted it and imaged V 1.4.1 It will boot up. If I make the network connections and then enter the licence details, it works until I turn off and start again next time. All I end up with is a b…
-
Thanks for your reply. Comments re graphic driver are noted. I'll check out the link you provided. I am running a genuine Raspberry Pi 3B and an Official Raspberry 7" Touch screen. I will always get the Repetier flash screen on boot and then a fe…
-
I did another clean install of windows with a new Raspberry image and everything is working well now. I don't know what had happened but did note some strange issues with windows recently, so I'd suggest something must have been corrupted which was…
-
I can connect to the PI from the laptop by using the IP address - this brings up repetier Server Pro - Aurora 54. Sorry, but I am not an expert on these issues so hopefully mt information assists with troubleshooting. One thing I have noticed that…
-
Thanks for your reply. Main power is connected to the Prusa. I can only get it to connect on Com 6 when the PC is connected to the printer via USB cable. If I set the printer up and then remove the USB, connection fails. "Port is visible" setting …
-
Repetier said: Yes you define it in connectivity. There you add the ip/port/apikey of the pc to the list on the pi and then pi can outsource it to the pc if it gets green. To not get out of memory/cpu there is in deed a queue system so only …
-
Thanks for your response. I feel a bit stupid....I was on the wrong screen whilst trying to configure the webcam. All good now and I have learnt something.