Not Able to Configure a 2-to-1 Mix/Switch Extruder
I have been successfully using Repitier FW in a dual extruder configuration with two nozzles/heaters and steppers. I replaced the separate nozzles/heaters with a 2-to-1 heater/nozzle and cannot get a configuration that does not result in an error with used on the printer.
I have tried about every combination of the mixing/sharing selection available and even tried to manually disable the second heater and use the extruder 0 sensor. Every combination I have tried has resulted in what must be undefined extruders and a repeating error buzzer. The extruders show up as def in the display.
I have been using the Dev version of the FW, but I've tried both .929 and Dev and get the same results. At one point it looked like a mirrored stepper would be the answer, but that results in a compiler error, flagging something that is undefined in the .H config files.