›

Acceleration/Travel acceleraion

RAyWBRAyWB
in Repetier-Firmware
As many slicers do not generate G0 moves , Travel acceleration is not used.
So two ways to go, replacing the G1 in fast moves by G0 in Gcode file , whats a ugly mess...
or switching over in Firmware (selected by feedrate).
but cannot find the correct position where to do this.
any suggestions?

Comments

  • RepetierRepetier
    G0/G1 are identical. Travel acceleration is used when there is no extrusion.
  • RAyWBRAyWB
    ok,thanks (althoug that makes no sense as it doesn´t  match gcode standards)
  • RAyWBRAyWB
    Repetier said:
    G0/G1 are identical. Travel acceleration is used when there is no extrusion.

    not shure if i understood correctly , so how to make a difference in Laser or CNC mode ?
  • RepetierRepetier
    In laser mode the difference is that G0 does not enable the laser. Travel acceleration is used if no extrusion happens. Apart from this there is no difference.
Sign In or Register to comment.