Diamond Mixedcolor Extruders


If i adjust my extruders, they have different Resolution.  
For example: Feed 100mm on every extruder. 

EXT1: 100mm
Ext2:  101mm
Ext3:  110mm

Is there any posibility to setup the Resolution for each extruder ?

This setting was gone after i set Mixing Extruder = 1

Thanks for Help


  • Hello again, 
    its ok. in configuration.h i still can change the setting. Only on the webpage configuration this setting is gone.

  • In config tool disable mixed extruder to change them and enable it back then. Older versions only used first resolution but that is now fixed.
Sign In or Register to comment.