Z-Axis not functioning correctly
I am trying to build my Ordbot 3D printer and I'm having problems with the settings for the Z azis motors. I have put in a resolution of 2560 steps/mm (8mm threaded rods) but when I try and move 10mm in the Z direction using the Repetier-Host Manual Control in only moves a quarter turn, very slowly, at a rate of about 18 seconds for a full turn. My X and Y axis work fine. Can anyone suggest what I might be doing wrong and what settings I can change.
I have used Repetier configuration tool 0.92.9 to make up my firmware and configuration.h file, Does anyone have a sample file for this type of printer that I can look at.