Core XY - one axis is always wrong
Hello, I am trying to install the Repetier FW on my CORE XY.
previously was for years Marlin on the printer, but since I also change to TCM drivers I have to I anyway to the FW.
at the moment the old drivers are still on it to not have all the problems at the same time.
For hours I plague with the problem that always runs at least axis Wrong around.
Example X is correct, but Y drives during homing in the wrong direction.
If I change the direction of Y
I trigger a homeing of Y drives the X axis brotal in front of the frame because of course the limit switch of Y can not trigger.
I have the feeling that every change achieves exactly the opposite.
I do not understand the logic behind this.
is there any other point besides INVERT_*_DIR
it can't be the wiring? under Marlin everything ran correctly.