Heater decoupled ?!?!?
I'm at a stage to give up. Problem, after problem/......
First, Nomather what I tell to the printer (firmware or EEPROM), EVERY TIME when I send G32 S0, THE FIRST row after G32 S0 in the log is: "Autoleveling is disabled"?!?!?!?!
I set "Autolevel active" to "1", I send S320 S2 - NO change.... AND ofcourse, because my bed is not perfect, the first pass is allways problematic!!!
HOW to enable this st...d "Autolevel" ?????
Second: After pausing print (because of WRONG Z0) followed by "Emergency Stop", printing proces do not start any more until restart the host !?!?!?! What is this? Why? It is normal after "Emergency Stop" everything to go to initial state... or?
Third: In the middle of the print (usually on the third layer) I receive: "Heater decoupled" and the extruder stops?!?!? The print proces (without extrusion) continue!!! WHY ???????????
Am I so stupid or what???