Z jerk too low?
I have just upgraded my firmware from 0.92 to 1.X (not dev version, the 1.0 available in the download page)
I didnt used the online configuration tool. I just downloaded the hole package, and copied all my settings from 0.92 to the new configuration.h file.
Compiled and uploaded new firmware. Seems ok, but in serial monitor, I can see this message: Z jerk too low, setting to 0.87
My z-jerk is set to 0.3 why is this being set to 0.87?????
I didnt used the online configuration tool. I just downloaded the hole package, and copied all my settings from 0.92 to the new configuration.h file.
Compiled and uploaded new firmware. Seems ok, but in serial monitor, I can see this message: Z jerk too low, setting to 0.87
My z-jerk is set to 0.3 why is this being set to 0.87?????
Comments
send
M502
M500
to update eeprom from config settings