Trouble with steps/mm settings

Kafe

aaaa new experience
#define EEPROM_MODE 0 
causes in software **Repetier Host**   config/Firmware EEPROM configuration/ window Firmware EEPROM settings
is EMPTY .....
so setting  step per MM working only from code arduino

#define EEPROM_MODE 1
causes in software **Repetier Host**   config/Firmware EEPROM configuration/ window Firmware EEPROM settings
Working ,and is possible change easy and quickly.

rixstaa

null
Tell us then? What the point in saying it easy and not telling us how to do it then?

Repetier

With the repetier server/host eeprom editor you can edit eeprom if enabled.

Roko

rixstaa said:

null
Tell us then? What the point in saying it easy and not telling us how to do it then?

Everything that we have tried to tell  you in your other post is well documented. You COULD have a bad board or incorrect wiring, as has been said before.
As an example, these links describes the firmware install and setup. It IS easy but you need to be meticulous about what you are doing to get it right.

https://www.repetier.com/documentation/repetier-firmware/repetier-firmware-introduction/
https://www.repetier.com/documentation/repetier-firmware/rf-installation/

TrevorSchmidt

where do i put these at?
#define XAXIS_STEPS_PER_MM  160                          
#define YAXIS_STEPS_PER_MM  160
#define ZAXIS_STEPS_PER_MM  8000

Repetier

x-axis steps per mm in eeprom.

Cncshop

#define EEPROM_MODE 0 
.................working......................................................

I stop my project  1 year ago  ...... But this is already available.

cazip

#define EEPROM_MODE 0  is ok. for eeprom change