X0 position after G29
Greetings,
I see this thing happening and would like to know if it is a right or a weird behaviour:
G28 Home axis, Xmin, Ymin, Zmin endstops, ok.
G1 X0 The nozzle goes to the bed border, ok.
G29 The nozzle goes to the specified points and the probe registers the height, ok.
G1 X0 The nozzle goes to a point 25mm on the right of the bed. This value is the same as X offset between nozzle and probe. IS IT OK?.
I would like to have again X0 placed on the border. Where do I can operate?
Many thanks.
Comments
Many thanks anyway.