Bed heating fine, neither extruder heating.
Just flashed today, new to all of this.
Davinci 2.0 Duo.
I flashed it with the .92 firmware. selected option 3 for printer and 1 for board (matches what I have)
The LCD screen doesent show anything, at all.. (no idea how to fix that either) but the printer is functional, sort of.
When trying to print the bed heats up fine, but neither extruder will heat at all, it tries for a bit and then gives a message : "sensor failure printer stopped and heaters disabled"
I know there is nothing wrong with the hardware, but im not very familiar with all of this just yet.
Can somebody point me in the right direction?
I flashed it with the .92 firmware. selected option 3 for printer and 1 for board (matches what I have)
The LCD screen doesent show anything, at all.. (no idea how to fix that either) but the printer is functional, sort of.
When trying to print the bed heats up fine, but neither extruder will heat at all, it tries for a bit and then gives a message : "sensor failure printer stopped and heaters disabled"
I know there is nothing wrong with the hardware, but im not very familiar with all of this just yet.
Can somebody point me in the right direction?
Comments
where would that setting be? Im running the .92 build so it was already a built file, Im not sure where to look.