tmp007 IR sensor on repetier firmware??
I'm having trouble figuring out what "temperature sensor" option to choose from for my Contact-less Infrared Thermopile Sensor Breakout - TMP007 on the Repetier Firmware.
I have it connected into the LCD pins where the SDA and SCL pins are located but cannot figure out what type of "temperature sensor" and which "temperature sensor pin" to choose from the options given for my heated bed. I am currently using a GT2560 board; the processor: Atmel 8-bit based board (e.g. Arduino Mega) and Motherboard: RAMPS 1.3/RAMPS 1.4.
Any help is greatly appreciated!