Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Extruder & Bed
Radds + 0.92.9 + MAX6675 Thermocouple
Disabling in Configuration.h DECOUPLE_TEST ????
How to tilt Chimera Hot End so Second Nozzle doesnt Collide with the printed Part? (Offset)
Add Choice in LCD Menu
Hotend and bed thermistors crazy values
"Error:One heater seems decoupled from thermistor - disabling all for safety" no hardware issue
Cooler Fun on Melzi (wanhao i3) switched earlier than specified in the gcode
cant make the extruder or bed to heat
Any possibility to read out temperature of Thermo coupled PWM fan?
Extruder not feeding correctly
Repetier FW + Simplify3D + Diamond hotend + FW retraction
Dead Time Control
Extruding too fast
Delta bed cupped - Need to manually adjust it out.
How to set up Diamond triple-filament single-nozzle mixing extruder on Rumba board
Diamond Hotend (3 extruder) and Repetier firmware
Z probe... How to define the 3 Points?
Extruder won't heat up to more than 185 degrees with PID control
Re Position the new extruder to the bed
Azteeg X3 PRO - Problems with third (..forth, fifth..) extruder
« Previous Page
Next Page »
Privacy Policy
|
About Us
