Loading...
This site is best viewed in a modern browser with JavaScript enabled.
Something went wrong while trying to load the full version of this site. Try hard-refreshing this page to fix the error.
Extruder & Bed
tmp007 IR sensor on repetier firmware??
1.0dev shoots too much filament
heating bed problem
Z probe not Working
Cooling fan constantly runs even when extruder is at room temp
New Z probing Design(temporarily disable endstop)
Z-test measures properly. but wrong track
Printer running over Endstops
Extruder going too high while probing
Mixing Nozzle / different steps per mm
Zprobed G32 makes zero Z to be 2mm above from bed. Z-probe height is measured with G30.
strange head motion...
Ultimaker, inductive probe and both Z endstops
Z-Probing error
Change X, Y offset by GCODE
Z_PROBE_Y_OFFSET Ignored by G29/G32 but OK in Bed height map
G33 correction grid z-offset
New Feature Request ? Or is implemented
Diamond Head / Cyclops Hotend - Mixing Head Extruder > 1 Not Working
Dual extruder weirdeness
« Previous Page
Next Page »
Privacy Policy
|
About Us
