-
MKS Rumba mit TFT "Checksum Error"
by Bonobo ·#undef FAN_BOARD_PIN -
Laser enable pin issue
by ChicoCybergoth ·#undef FAN_BOARD_PIN -
RepRapD1scount Smart Controller
by silver1882 ·#undef FAN_PIN -
Mirrored Extruder spins with Z on Home and Raise
by RandalZimmer ·#undef FAN_BOARD_PIN -
Z axis not moving at all on COREXY
by Bleachworthy ·#undef FAN_BOARD_PIN -
1.0.4dev homing problems -CR10S (Crealty 2.1 board)
by badvision ·#undef FAN_BOARD_PIN -
Afinibot A3 upgrade problems
by jonarotz ·#undef FAN_BOARD_PIN -
Linear advance extruder stops
by overdrive ·MANUAL SETTINGS ########################## //#undef FAN_BOARD_PIN //#define FAN_BOARD_PIN -1 //#define BOARD_FAN_SPEED 255 //#define BOARD_FAN_MIN_SPEED 0 //#define FAN_THERMO_PIN -1 //#defin -
sd card does not work no 1.0.2
by csmith ·#undef SDCARDDETECT -
No voltage output on D10 pin while G1/G2/G3 command in laser mode
by rdzawka ·#undef FAN_BOARD_PIN -
Print randomly pausing at retract
by opy01 ·#undef FAN_BOARD_PIN -
sd card does not work no 1.0.2
by csmith ·#undef SDSUPPORT -
BLTouch not working
by neoh ·#undef FAN_BOARD_PIN -
Z probe height
by The_Geak ·#undef SDCARDDETECT -
Problem with Z axis
by Dave_Da48 ·#undef PS_ON_PIN -
MABL mit BL Touch
by Bonobo ·#undef FAN_BOARD_PIN -
Problem using 3 Z steppers and bed leveling
by bryanbdp ·#undef FAN_PIN -
problem with firmware
by j_tmec ·#undef FAN_BOARD_PIN -
Heated bed not working
by CSchiavoni ·#undef FAN_BOARD_PIN -
RAMPS-FD + Geetech RAMPS-FD Adapter + RepRap Full Graphics Smart Controller
by Repetier ·#undef SDCARDDETECT